MTH Electric Trains E-33 Instructions d'exploitation télécharger pdf (Page 5)

E-33 Rectifier Operating Manual

In order for Proto-Sound® to properly initiate the system check, do not

advance the transformer throttle past 10 volts when you first enter RESET,

wait for the electric startup sounds to begin and then slowly turn the

transformer throttle to the off position and then back on again to enter the

forward phase. Interrupting the power too quickly may cause the system to

re-enter RESET (signaled by two dings of the bell). Should this happen,

wait longer before interrupting the power to enter the Forward phase.

Proto-Sound® comes with several programmable functions, including

Engine Volume Adjustment, Separate Bell Button Operation

(pre-programmed at the factory), Cab Chatter On/Off Control, ProtoCoupler

On/Off Control and Horn-In-Neutral Operation. Each of these features are

described in more detail later. You will notice that when in RESET, your

engine will not respond to the whistle button with a horn blast or continuous

bell ringing. In fact, when in RESET and the whistle button is depressed,

only one single bell chime will be heard each time the whistle button is

pressed. If you don’t want to configure or change your locomotive using

any of these programmable features, simply leave RESET and wait 2.2

seconds before interrupting the power to put the engine in forward. After

you leave RESET, your engine will operate normally in all the direction

states of forward, neutral and reverse.

HORN OPERATION

Your MTH E-33 Rectifier ProtoSound-equipped engine is equipped with a

digital recording of a E-33 Rectifier Whistle. The whistle sound can be

activated anytime the engine is in forward or reverse by pressing the whistle

button on your transformer. The whistle will continue to blow as long as

the whistle button is depressed. The whistle will not function in RESET

and must be configured through a RESET option to allow the whistle to

work when the engine is in neutral. See page 20 for information on whistle

programming in the Using RESET To Program Proto-Sound® section of

this manual.

BELL OPERATION

Your MTH E-33 Rectifier Proto-Sound® engine is equipped with a digital

recording of an actual bell. Unlike previous versions of Proto-Sound®, the

bell can be turned on or off with any separate bell button, like the Lionel®

Railsounds® No. 5906 Bell Button, by simply pushing the button. If you

don’t have a separate bell button, the bell can be controlled through your

transformer’s whistle button whenever the engine is in NEUTRAL. The

1 2 3 4 5 6 7 8 9 10 ... 35 36

Pas de commentaire

MTH Electric Trains E-33 Instructions d'exploitation Page 5