MTH Electric Trains PA B-Unit Spécifications télécharger pdf (Page 42)

Start-up Solution

When I apply power to the track

my engine doesn’t do anything. No

lights, no sound, no nothing.

This is normal. You have to hit the

Start-Up button.

Check to see if that section of track

has power. Use a voltmeter or a lit

passenger car, not your tongue.

Slide the engine a couple of feet in

either direction, you may have a bad

track section

Have you got that section electrically

isolated with a toggle switch or other

device?

I get an error when I hit Start-Up Have you recently changed the

engine address?

Check if there is power on that

section of track the engine is sitting

on (there has to be power for the

signal to get to the engine and for the

engine to be able to hear it)

If you have two engines on the track

they both may have the same address.

Take one of them off the rails and try

it again

DCS is polarity sensitive when

powered by a DC power supply.

Check the polarity of the DC power

supply connected to the Fixed 1 or

Fixed 2 Inputs. Shut down power,

reverse the inputs and repower DCS.

Hitting the startup button the DCS

remote should start up the

locomotive.

Sound

Solution

I have no sound on my engine, but

my lights are on and it moves just

fine

You may have it turned off.

Repeatedly press VOL + to bring the

Master Volume up

Did you turn off the ENG Sounds?

Press the ENG SND button on your

DCS controller.

Check that you haven’t lowered any

of the independent engine volumes

(Eng Sounds, Bell, Whistle, or

Accent)

When I run Doppler I can hear the

Doppler shift but then the engine

sounds fade out and I can’t get

them back

This is normal. You will need to

press the Doppler button again to turn

Doppler off. Your engine sounds will

now return to normal

DCS (Remember, it's NOT DCC)

M.T.H. HO Alco PA/PB Diesel Engines

42

1 2 ... 37 38 39 40 41 42 43 44 45

Commentaires sur ces manuels

Pas de commentaire