MTH Electric Trains PA B-Unit Spécifications télécharger pdf (Page 21)

Crossing Signal

Again, just like a real engine, you can trigger the Crossing Signal on your engine.

This is two long, one short, one long whistle/horn blast.

F11 – Crossing Signal

Pressing F11 twice (toggling on then off) will sound your Crossing Signal.

Smoke (if equipped)

You can control PS3.0-equipped engines that have smoke by toggling F12 on or off.

You can also adjust the smoke output using F13. Some engines have a switch to

enable/disable smoke and others have a smoke volume pot. In the case of a switch,

ensure the switch is set to ON and in the case of a smoke volume pot, ensure the

pot is turned fully clockwise to enable smoke operation in DCC.

F12 – Smoke On/Off

Enabling F12 will turn the smoke unit on. Disabling F12 will turn your smoke unit off.

F13 – Smoke Volume

There are three smoke volume levels in your MTH PS3.0-equipped engine –

Low/Med/High. The default for this is set to High. You can adjust the smoke

output (amount of smoke the generator puts out) by pressing the F13 button twice.

This sets the level to the next step. For example, if you are currently at the High

smoke output level, pressing F13 twice (toggling it on then off) will set the smoke

volume to Low. Pressing F13 twice again will set it to Medium and so on.

Engine Sounds

F25 – Engine Sounds

You can turn the Engine Sounds On/Off by pressing the F25 button. Pressing it

once (enabling F25) will cause the Engine Sounds to shut off. The Whistle/Horn

and Bell sounds will still be active, however. To turn the engine sounds back on

press the F25 button again (disable F25).

CV29

CV29 is the basic decoder setup CV that is used by all DCC decoder manufactures.

So, if you are familiar with CV29 from other manufacturer's decoders MTH's is no

different. The most important part of CV29 is the ability to switch between long

and short addressing. By default, CV29 on your MTH PS3.0-equipped engine is set

to 2.

Long and Short Addressing

Like most DCC Decoders, your MTH PS3.0-equipped engine can be programmed

with both Long and Short Address. Short addresses are those from 1-127 and Long

M.T.H. HO Alco PA/PB Diesel Engines

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 44 45

Pas de commentaire

MTH Electric Trains PA B-Unit Spécifications Page 21