MTH Electric Trains AEM-7 Manuel de l'opérateur télécharger pdf (Page 8)

Premier AEM-7 and ALP-44 Electric Engine with PS-2

Front Coupler:

To fire the front coupler (if your engine has one), quickly tap the Bell button once followed

by four quick taps of the Horn/Whistle button, allowing approximately ½ second to lapse

between each quick button press. The sound of the liftbar and air line depletion will play,

and the knuckle will be released.

Speed Control:

M.T.H. engines equipped with Proto-Sound 2.0 have speed control capabilities that allow the

engine to maintain a constant speed up and down grades and around curves, much like an

automobile cruise control. You can add or drop cars on the run, and the engine will

maintain the speed you set.

While the engine is programmed to start with the speed control feature activated, you can

opt to turn it off. This means the engine's speed will fall as it labors up a hill and increase as

it travels downward. It is also affected by the addition or releasing of cars while on the run.

Because the engine will run more slowly at a given throttle voltage when speed control is on

than when it is off, you should adjust the throttle to a lower power level for operation with

speed control off to avoid high-speed derailments. When speed control is off, the volume

will drop to allow for better low voltage operation.

To turn speed control on and off, put the engine in neutral, then quickly tap the

transformer's horn/whistle button one time then quickly tap the Bell button two times,

allowing approximately ½ second to lapse between each quick button press. Repeat the 1

horn/whistle, 2 bells code to return it to the other condition. You will want to do this

during the initial neutral upon start-up if you ever couple this engine to another engine that

is not equipped with speed control to avoid damaging the motors in either engine. Each

time you shut down the engine completely, it will automatically turn speed control on.

Lock into a Direction:

You can lock your engine into a direction (forward, neutral, or reverse) so that it will not

change directions. To do this, put the engine into the direction you want (or into neutral to

lock it into neutral), run it at a very slow crawl (as slowly as it will move without halting), and

quickly but firmly tap the Horn/Whistle button once followed by three quick taps of the

Bell button, allowing approximately ½ second to lapse between each quick button press.

Two horn/whistle blasts will indicate that the engine has made the change. The engine will

not change direction (including going into neutral) until you repeat the 1 horn/whistle, 3

bells code to return the engine to its normal condition, even if the engine is kept without

power for extended periods of time.

whistle

Speed Control

Two Whistle Blasts

(indicates change is made)

Repeat to Return

to Normal Condition

Direction Lock

Two Whistle Blasts

(indicates change is made)

Repeat to Return

to Normal Condition

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

MTH Electric Trains AEM-7 Manuel de l'opérateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Jouets et accessoires MTH Electric Trains AEM-7